How Do I Get Rid Of The Mote Moisture App

Home
Professional Electronics, VLSI and Embedded Systems
Internet of Things IOT
IoT Systems

Systems

Ubimote

Ubimote is a System on Chip based Low Power and Medium range RF communication module compliant to IEEE802.15.4 supporting a maximum transmitting power of +7 dBm. Ubimote supports application development platforms like Contiki OS, Zigbee and custom stacks.

Features:

Highly integrated System on Chip with ARM Cortex M3 microcontroller with
- Up to 32-MHz Clock Speed
- Up to 32KB of RAM (16KB With Retention in All Power Modes)
- Two timers (16/32 bit)
- 512KB of In-System Programmable Flash
- Supports On-Chip Over-the-Air Upgrade (OTA)
- Battery Monitor and Temperature Sensor
- 12-Bit ADC With 2 Channels and Configurable Resolution
- USB 2.0 Full-Speed Device (12 Mbps)
- Four Universal Serial Communication Interfaces (USCIs)- SPI, UART, I2C
External Flash Memory
- 8Mb Flash memory, Up to 75 MHz clock frequency
- SPI Interface , Write Protection, Deep Power Down Mode
RF subsystem
- ISM Band RF Transceiver with RF frequency range 2394-2507 MHz (2.4 GHz)
- IEEE 802.15.4 compliant DSSS baseband modem with 250 kbps data rate
- Low Power (RX -97dBm @ 20 mA, TX 0 dBm @ 24 mA)
- Ultra low power down mode (<1.3Î¼A)
- Good receiver sensitivity (-100 dBm), Adjacent channel rejection: 44 dB and Alternate channel rejection: 52 dB
Security sub system
- Future Proof AES-128/256, SHA2 Hardware Encryption Engine
- Optional - ECC-128/256, RSA Hardware Acceleration Engine for Secure Key Exchange
Expansion headers for connecting Ubi-Sense, Ubi-DAC and external sensors
Intelligent power system with rechargeable lithium polymer battery and solar energy harvesting

BLE mote

BLE mote is a system on chip based device for Bluetooth Low Energy based applications. This mote is compliant to the Bluetooth 4.0 standards with Low Energy Profile support.

Features:

Highly integrated System on Chip with ARM Cortex M0 microcontroller with
- 32 kB RAM, 256 kB flash Memory
- Supports various Serial Communication Interfaces like SPI, UART, I2C, Timers, ADC
- CPU independent Programmable Peripheral Interconnect (PPI)
- Real Timer Counter (RTC)
- Watchdog Timer (WDT)
External Flash Memory
- 8Mb Flash memory with Write Protection and Deep Power Down Mode
RF subsystem
- 2.4 GHz ISM Band RF Transceiver compliant to Bluetooth 4.0 LE standards
- 250 kbps, 1 Mbps, 2 Mbps supported data rates
- GFSK Modulation
- Programmable Transmit power of +4 dBm to -20 dBm (in 4 dB steps)
- High Receiver Sensitivity (-93dBm in BLE)â€"Low Power (Peak Rx -93dBm @ 13 mA, Peak Tx 0dBm @ 10.5 mA)
- Ultra low power multiple down modes
Security sub system
- AES Hardware Encryption Engine (AES Electronic Codebook Mode Encryption, AES CCM Mode Encryption), Accelerated Address Resolver, Random Number Generator
Expansion headers for connecting Ubi-Sense, Ubi-DAC and External Sensors
Intelligent power system with rechargeable lithium polymer battery

Wi-Fi mote

It is based on Wi-Fi Certified wireless MCU with built-in Wi-Fi protocol stack targeted for Internet of Things (IoT). The maximum RF transmitting power is up to +18dBm. For the application development Free-RTOS and TI-RTOS can be easily integrated.

Features:

High-performance ARM Cortex-M4 MCU with
- Wi-Fi Network Processor with 802.11 b/g/n Radio, Baseband, MAC, Wi-Fi driver
- Power-Management Subsystems with integrated DC-DC converters
- RAM of 256KB
- External Serial Flash Boot loader
- 2 General-Purpose Timers with 16-bit PWM mode
- 2 Channel 12-bit ADCs
- Clock sources with 40MHz and 32.768kHz
- Four Universal Serial Communication Interfaces (USCIs)- SPI, UART, I2C
- Provides an application throughput of maximum 16Mbps
- Supports Station, Access Point, and Wi-Fi Direct modes
External Flash Memory
- 8Mb Flash memory, Up to 75 MHz clock frequency
- SPI Interface , Write Protection, Deep Power Down Mode
Wi-Fi network processor subsystem
- Dedicated ARM MCU completely offload the host MCU
- Robust 802.11 b/g/n radio, baseband, and MAC
- Powerful crypto engine for a fast, secure WLAN and Internet connections with 256-bit encryption.
- Supports WPA2 personal & enterprise security and WPS 2.0.
- Embedded IPv4 TCP/IP stack
Security sub system
- Hardware Crypto Engine for Advanced Fast Security including AES, DES, and 3DES, SHA2 and MD5, CRC and Checksum
Expansion headers for connecting UbiSense, UbiDAQ and any other external sensors
Intelligent power system with rechargeable lithium polymer battery

WINGZ (Wireless IP Network Gateway for Zigbee)

Features

Processor
- ARM Cortex-A9 application Processor(Single/dual/quad)
- CPU clock speed up to 1GHz
- 2D and 3D graphics co-processors
Power Management
- Advanced power management system with module wise power control
- Flexible power input with dynamic source switching
- Integrated Li-Ion battery management with solar energy harvesting capability
- Dynamic Voltage and Frequency Scaling
Memory
- 1 GB/2 GB DDR3 SDRAM
- 4GB/8GB onboard eMMC flash memory
- External Micro-SD card support (up to 32GB)
- 4Mbytes Serial Flash
Connectivity
- Onboard Gigabit Ethernet (RJ45) ports
- Two USB 2.0 host type A ports
- One USB-OTG Port
- One High speed CAN (DB-9) port
- Supports various Serial Communication protocols like SPI, I2C, UART
Display
- Onboard 7â€ LCD with capacitive touch panel
- High Definition Video Output through HDMI Port
Camera
- Supports CMOS Camera (Optional 5MP Raspberry Pi camera)
- Supports various USB based web cameras
Audio
- High quality Stereo audio codec
- Mobile phone compatible 3.5mm audio port for Audio In/Out
Wireless Connectivity
- High Range IEEE802.15.4 (ZigBee/6LoWPAN) Transceiver (upto 22dBm Tx power)
- Dual Mode Bluetooth4.0 Connectivity (with BLE profile)
- IEEE802.11b/g/n compliant WLAN (Wi-Fi) Modem
- 3G Cellular Network Connectivity (GSM/GPRS/EDGE/HSPA+)
- GPS/NGSS Positioning system
Onboard Sensors
- Temperature and Relative Humidity Sensor
- Digital Ambient Light Sensor
- 3-Axis Digital Accelerometer
Debug Interface
- JTAG connector (20-pin) for Main Processor
- SWD connector for BLE SoC
OS Support
- Linux
- Android
- Windows*
Application
- Gateway device between the WPAN and IP network
- Coordinator device for the WPAN networks
- Indoor/Outdoor deployment of Internet of Things solutions
- Single board computer
- Unified control and monitoring console for various wireless networks

Add-on cards

Ubi-Sense

Ubi-Sense is a generic sensor board having the following listed sensors.

Sensors

Temperature and Relative Humidity
Light Intensity
Barometric Pressure
Proximity sensing
Buzzer

All the sensors can be interfaced with microcontroller via I2C bus. It contains additional I2C connector for connecting external I2c compliant sensors to the communications modules. Ubi-Sense mates with all three Ubimote, BLE mote and Wi-Fi mote through their expansion connector and sensor interface libraries are available for all the communication modules

Ubi-DAQ

Ubi-DAQ is a data acquisition card which contains peripherals like ADC, RTC, IO expander and Relay. All the peripherals can be interfaced with microcontroller via I2C bus. Each peripheral on Ubi-DAQ has unique I2C address. This card provides additional analog and digital IO capability to the communications modules for connecting more number of sensors

Features

Single Ended and Differential 8 Analog channels
8 Digital channels
RTC support
High drive capability Relays

Optional/ Additional systems

C-Mote

The C-Mote is a Wireless communication module designed with a robust RF front end and highly flexible power management system.

Features

IEEE 802.15.4 compliant WSN platform
Two-chip solution based on the popular CC2520 transceiver along with ultra low power MSP430 MCU
High range with +5dBm output power and Compliant to IEEE 802.15.4
Over The Air Programming
Dynamic Voltage and Frequency Scaling for effective power management
Application development using TinyOS, Contiki-OS and Custom stacks
IP65 certified enclosure
Smart Power Management with Solar Energy Harvesting
Usage
Can be used as coordinator/ router or end device
Indoor/outdoor deployment as sensor node.

Ubimote-HR

This mote is a high range variant of Ubimote supporting a maximum RF trasmit power of +20 dBm.

Wireless accelerometer and wireless T& RH sensor

These two modules are dedicated sensor embedded Zigbee modules of tiny size and operate with a small battery as power source. These modules come with debug connector and embedded sensor on a communication module in a tiny size.